Table of Contents
Advertisement
Figure 45
1. Battery
2. Bar
3. Positive cable
5.
Disconnect the negative (black) ground cable
from the battery post
fasteners.
6.
Slide the rubber cover off the positive (red)
cable.
7.
Disconnect the positive (red) cable from the
battery post
(Figure
8.
Gently push the hydraulic hoses aside and lift
the battery out of the chassis.
4. Rubber cover
5. Negative cable
(Figure
45). Retain the
45). Retain the fasteners.
Charging the Battery
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1.
Remove the battery from the machine; refer to
Removing the Battery (page
2.
Charge the battery for 10 to 15 minutes at 25 to
30 A or 30 minutes at 4 to 6 A
not overcharge the battery.
g005293
1. Positive battery post
2. Negative battery post
3.
When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts
(Figure
Cleaning the Battery
Note:
Keep the terminals and the entire battery case
clean, to help extend battery life.
1.
Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2.
Shut off the engine and remove the key.
3.
Remove the battery from the machine;
Removing the Battery (page
4.
Wash the entire case with a solution of baking
soda and water.
5.
Rinse the battery with clear water.
6.
Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
7.
Install the battery; refer to
(page
37).
36
35).
(Figure
Figure 46
3. Red (+) charger lead
4. Black (-) charger lead
46).
35).
Installing the Battery
46). Do
g003792
Advertisement
Table of Contents
