Toro 22342HA Operator's Manual page 28

Installing the Side Screens
Slide the side screens into place in the slots in the
front screen and frame.
Removing the Front Screen
CAUTION
If the engine has been running, the heat shield
will be very hot and could burn you.
Allow the machine to cool completely before
touching the heat shield.
1. Open the hood and remove both side screens.
2. Loosen the bolts securing the weights
29).
Figure 29
1. Front weight
2. Bolts
3. Sloped plate
3. Remove the carriage bolts and nuts securing the
sloped plate (Figure
4. Lift the sloped plate up and off the machine.
5. Remove the 4 bolts securing the front screen to
the frame (Figure
(Figure
4. Carriage bolts
5. Rear weight
29).
30).
1. Front screen
6. Remove the shoulder bolts and nuts securing
the oil cooler to the top of the front screen
(Figure 31).
g013122
1. Nut
2. Oil cooler
7. Remove the front screen.
8. When finished, install the front screen with the 4
bolts removed previously.
9. Install the oil cooler to the front screen with the 4
shoulder bolts and nuts removed previously.
10. Slide the sloped plate between the frame and
the weights; secure it to the front screen grill
using the carriage bolts and nuts removed
previously
28
Figure 30
2. Bolts (left side bolt not
shown)
Figure 31
3. Front screen
4. Shoulder bolts
(Figure 29).
g004188
g004189