Table of Contents
Advertisement
Figure 68
1. Black wire
2. Orange wire
3. Fuel-tank-vent fitting
13.
Disconnect the vent hose from the fitting on top
of the tank. Plug the fitting so that no fuel can
leak out during the procedure.
14.
Carefully remove the tank and set it upright to
keep from spilling the fuel.
DANGER
In certain conditions, fuel is extremely
flammable and highly explosive. A fire
or explosion from fuel can burn you and
others and can damage property.
Refer to
Fuel Safety (page 15)
complete list of fuel related precautions.
15.
Remove any large deposits of debris.
16.
Wash out the chassis with water until the water
running out the back of the unit is clear.
Important:
Take care not to get water into
the engine or electrical components.
17.
Slide the fuel tank part way into the chassis
(Figure
67).
18.
Remove the plug from the vent fitting and
connect the vent hose to it.
g013123
4. Vent hose
5. To the carbon canister
for a
19.
Connect the fuel line and remove the clamp.
20.
Secure the tank cap and tighten it until it clicks.
21.
On the right side of the tank, connect the orange
wire to the center post and the black wire to the
outside post
(Figure
22.
Slide the tank all the way into the machine.
Important:
The fuel line and wires must be
away from the engine pulleys and the frame.
23.
Replace the rear panel and secure it with the 6
bolts and nuts removed previously
24.
Secure the battery tray with the bolts and
washers removed previously.
25.
Install the side weights with the bolts, washers,
and lock washers removed previously
67).
26.
Close the rear-access cover.
27.
Lower the machine to the ground.
49
68).
(Figure
67).
(Figure
Advertisement
Table of Contents
