Toro 22342HA Operator's Manual page 42

Figure 54
1. Spring-removal tool
2. Drive belt
3. Idler pulley spring (spring
cover not shown)
5. Remove the idler pulley spring from the
idler-pulley assembly
4. Idler pulley
5. Engine (see-through for
illustrative purposes)
(Figure 55).
1. Idler-pulley assembly
6. Remove the belt from the 3 pulleys
g005547
7. Install a new drive belt around the 3 pulleys
(Figure 55).
8. Install the end of the idler pulley spring to the
arm on the idler-pulley assembly.
Important:
cover, ensure to install it over the spring at
this time.
9. Using the spring-removal tool, pull the idler
spring hook up and around the stud on the
traction unit, pulling the idler pulley tight.
10. Remove the spring-removal tool from the spring
and close the hood.
42
Figure 55
Spring cover not shown
2. Drive-belt routing
Figure 56
Spring cover not shown
If you have removed the spring
g243518
(Figure 56).
g005549