Setup; Receive Mode - Silvercrest SWED 100 A1 Operating Instructions Manual

Setup

• Unfold the telescopic aerial
• Push out the support
Then turn the telescopic aerial

Receive Mode

a) Switch appliance on/off
• To switch the device on, press the button "POWER ON"
• The green POWER LED
• To switch the device off, press the button "POWER OFF"
b) Adjusting the reception
• If you have switched the device on by pressing the button "POWER ON"
first select the reception range FM, AM or SW 1-7. For this, slide the wave-
band selector switch
• Then search for the desired radio station by slowly turning the tuning
regulator "TUNING"
the frequency just received is shown digitally, together with the unit
"MHz" (Megahertz) or "kHz" (Kilohertz).
c) Adjust sound volume
• Set the desired volume level using the volume regulator "VOL"
d) Switching the display illumination on
• Hold the button "LIGHT"
illumination.
³
and draw it out to its full length.
if you wish to position the appliance at an angle.
³
to a slanted upward angle.
glows for as long as the device is switched on.
¿
into the appropriate position.
until you have clear reception. In the display
pressed down to switch on the display
- 7 -
.
¶
.
´
.
,