Using The Headphones; Replacing The Ear Pads - Silvercrest SBKL 5.0 A1 Operating Instructions And Safety Instructions

SilverCrest SBKL 5.0 A1
deleted and your headphones revert to pairing mode. You can then
connect a different compatible Bluetooth® device to the headphones.
See step 2 in the previous section.

9.3 Using the headphones

Make sure you fit the headphones correctly based on the labels on the
earpieces: R = right, L - left. The control panel with the buttons is on the
right-hand side of the headphones.
1. Place the neck band around your neck and then carefully place one of
the earpieces into your ear. To make insertion easier, you can
straighten your ear slightly by pulling the outer ear gently back and up.
Proceed with the second earpiece in the same way.
The medium-sized ear pads are fitted as standard. If the earpiece does not
sit correctly or does not fit, replace the ear pads with the large (C) or small
(D) ones. The section below describes how to do this.

9.4 Replacing the ear pads

The medium-sized ear pads are fitted as standard. If the ear pads do not
fit correctly, you can replace them. Proceed as follows:
1. Carefully pull the ear pad off the ear
adjuster piece using your fingers.
2. Carefully remove the ear adjuster piece
from the earphone.
3. Select the ear pad and ear adjuster
pieces you want, either large (C, D) or
small (E, F).
4. Push the ear adjuster piece (C or F) onto
the earphone until it clicks into place.
44 - English