Dell W2600 Owner's Manual page 84

Problem
Poor picture quality when using a device
connected to the ANT/Cable (coaxial)
connector
Nothing appears on my wide LCD monitor
Possible Solution
Ensure wide LCD monitor is selected as the input
1
source in the Input Select menu. See "Input Select
Menu" on page 74 for more information.
Press Menu on the remote control, select Setup, and
2
then select Channel Setup. This resets the channels.
Check the aspect ratio settings in the OSD. Press the
3
Menu button on the remote control and select Size. For
more information on using the OSD, see "Using the On-
Screen Display" on page 73.
Reset the original factory defaults. Press Menu on the
4
remote control, select Setup, and then select Factory
Reset.
Adjust the color temperature. Press Menu on the remote
5
control, select Picture, and then select Color
Temperature.
The problem may be with your device, contact your
6
service provider.
Ensure the wide LCD monitor is turned on.
1
Verify that all the cables are properly connected to the
2
wide LCD monitor , including the power cable.
Check to see if there is a blue or amber light on the
3
lower, right-hand corner of the wide LCD monitor . A
blue light indicates the wide LCD monitor is on. An
amber light, means the wide LCD monitor is in power
save mode.
Ensure the proper source is selected in the Input Select
4
menu. See "Input Select Menu" on page 74 for more
information.
Reconnect any devices that are currently connected to
5
the wide LCD monitor . If you are using multiple
devices, connect and test one device at a time.
Connect another device that you know is working
6
properly.
Reset the original factory defaults. Press Menu on the
7
remote control, select Setup, and then select Factory
Reset.
Troubleshooting Your Wide LCD Monitor
83