Advertisement
Figure 20
1. Switch, with notch in the
rear
2. Remove the cover
C. Holding the switch cover in position, flip
the switch body 180 degrees so that the
connector notch is front left corner (Figure
20).
D. Press the rocker switch covers onto the
switch bodies in this new orientation until
the cover snaps into place (Figure 20).
E. Install the switches to there original
position in the control panel.
Note: Ensure that the orientation of the
switch is with the notch pointing toward
the top left of the control box.
Wiring the Switches and Indicator Light
1. Cut and remove the existing grommet in
the base of the control panel. Discard the
grommet.
Important: Take precautions not to
cut the existing wires and harness when
cutting out the existing grommet.
2. Route the free end of the wiring harness up
through the opening in the control panel
keeping the branch with the ring terminal
outside the control panel.
3. Split the new grommet included in the kit and
wrap the around the wiring harness at the base
of the control panel. Install the grommets
to the base of control panel in place of the
grommet removed previously.
3. Switch body, rotated 180°
4. Install cover, notch in the
front
4. Connect the connector with green/white,
green/black, and black wires to the bottom of
the right boom lift switch.
5. Connect the connector with blue/white,
blue/black, and black wires to the bottom of
the left boom lift switch.
6. Connect the connector with purple, white,
yellow, and black wires to the bottom of the
sonic boom switch.
7. Connect the light indicator to the wiring
harness with two spade connectors.
8. Install the front control panel cover to the
control box using the fasteners removed
previously (Figure 18).
9. Route the remainder of the harness rearward,
along the existing sprayer harness to rear of the
machine. Use cable ties to secure the harnesses.
Connecting the Wiring to the Fuse Block
1. Locate the branch of the wiring harness with
the ring terminals and route it under the dash
to the fuse block area.
2. Connect the ring on the black wire to the
ground bolt (Figure 21).
Figure 21
1. Fuse block
2. Red wire, from harness
3. Corresponding wire, from
fuse block
3. Remove the short extension wire from the red
wire and connect the black connector to the
mating connector in the fuse block.
12
4. Black wire
5. Ground bolt
Advertisement
