Advertisement
Step
1
Installing the Ultrasonic
Sensors
Parts needed for this step:
2
Ultrasonic sensor
8
U-bolts
8
Washers (5/16 inch)
8
Locknuts (1/4 inch)
2
Rubber sensor cover
2
Protection tube
4
Wire clips
10
Cable ties
Procedure
Use the following procedure for boom systems
260000001 and up.
1. Park the sprayer on a flat surface, lower the
booms, set the parking brake, stop the engine,
and remove the key.
2. Lightly secure the right ultrasonic sensor to the
right boom pipe halfway as shown in Figure
1, using 2 U-bolts, 4 washers (5/16 inch), and
4 locknuts (1/4 inch). Do not fully tighten at
this time to allow for later adjustment.
Figure 1
1. Sensor
2. U-bolts
3. Locknuts and washers
4. Protection bar
3. Install the rubber sensor cover to the threaded
portion of the ultrasonic sensor.
4. Install the protection tube around the
ultrasonic sensor with the angled side facing
inward, toward the vehicle. Lightly secure the
protection tube to the boom (Figure 1), using 2
U-bolts, 4 washers (5/16 inch), and 4 locknuts
(1/4 inch). Do not fully tighten at this time to
allow for later adjustment.
5. Rotate the sensor and protection tube up
so that it is approximately 25 degrees above
parallel with the ground, then tighten all the
locknuts on the U-bolts to secure the sensor
and projection tube (Figure 2).
Figure 2
6. Thread the ultrasonic sensor wire through the
strap of the rubber cover.
7. Route the sensor wire along the top of the
boom support to the slide block (Figure 3).
Secure it to the top of the boom using clips
provided.
3
Advertisement
