Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Ultrasonic sensor
U-bolts
Washers (5/16 inch)
Locknuts (1/4 inch)
1
Rubber sensor cover
Protection tube
Wire clips
Cable ties
Mount plate
Relay
Bolt (1/4 x 5/8 inch)
Lock washer (1/4 inch)
Nut (1/4 inch)
Wire harness
Screw (#10)
2
Nut (#10)
Electronic Control Unit (ECU)
Bolt (1/4 x 2-1/2 inch)
Bolt (5/16 x 3/4 inch)
Lock washer (5/16 inch)
U-bolt clamps
Nut (5/16 inch)
Decal, 94-8582
3
Light assembly
Rocker switch
4
Cable ties
Indicator light
6
Grommet
7
Conversion wires (Older boom lifts
only)
8
No parts required
Note: The Sonic Boom Kit requires electric boom lift actuators to automatically raise and lower the
booms. Most machines have had electric boom actuators installed or are being installed in concert with
this Sonic Boom Kit. The setup procedures that follow were developed for these situations. If you do
not have electronic boom lift actuators installed or available to be installed, contact your Authorized Toro
Dealer to obtain the correct parts to modify your sprayer to be compatible with the Sonic Boom Kit. The
necessary parts are: Electronic Boom Lift Actuators (2), Fuses (2), and Switches (2).
Note: Determine the left and right sides of the machine from the normal operating position.
Description
2
Qty.
2
8
8
8
Install the ultrasonic sensors.
2
2
4
10
1
6
4
8
8
1
2
Mount the electronic controls.
2
1
4
2
2
2
4
1
Install the indicator light.
1
1
Install the controls
6
1
Install the controls on a Workman
spray system.
1
Connect the wiring to the sensors
2
and actuators.
–
Calibrate the sonic booms.
Use
Advertisement
