Product Overview; Controls - Toro ProCore Operator's Manual

Product Overview

Controls

Brush/Chopper
Note: There are no controls to turn the Brush/Chopper
On or OFF. The chopper/brush will engage when the
engine RPM is increased and disengage when the throttle
is moved to low idle or when the engine is stopped.
Lift/Offset Controls
The lift/offset functions run off the tow vehicle
hydraulic system. Refer to the tow vehicle operator
manual for hydraulic system control information.
Note: The lift/offset control will only function when
the core processor engine switch is in the "ON" position.
Lift/offset switch
The lift/offset switch (Figure 25) allows tow vehicle
hydraulic system to operate in the lift or offset mode.
Engine Stop Switch
Press the switch to stop the engine (Figure 25).
Figure 25
1. Lift/offset switch
Important: If you need to stop in a hurry, the first
thing to do is lift the aerator. If you stop the tractor
before you lift the aerator, turf damage will occur.
Choke Control
To start a cold engine, pull choke control lever
(Figure 26) out to the ON position.
2. Engine stop switch
Ignition Switch
The ignition switch (Figure 26) which is used to start
and stop the engine, has three positions: OFF, RUN and
START. Rotate key clockwise to the START position
to engage the starter motor. Release the key when the
engine starts. The key will move automatically to the
ON position. To shut engine off, move throttle control
to SLOW position and wait for the engine to decelerate
before moving the key counterclockwise to the OFF
position.
Throttle Control
The throttle (Figure 26) is used to operate engine at
various speeds. Moving throttle lever to FAST position
increases engine speed. To decrease engine speed, move
lever to SLOW position. Always run the engine at full
throttle.
1. Throttle control
2. Choke control
Hour Meter
The hour meter (Figure 27) indicates the total hours of
machine operation.
1. Hour meter
20
Figure 26
3. Ignition switch
Figure 27