4.4 Associate Handheld and Base Unit
The OO-2H02-7588 must establish communications with base unit BU-2H06D-7588 before the
system can be used. The OO-2H02-7588 handheld remote is associated to the system base unit
before leaving the factory. This is done using the Associate procedure. In situations where it is
necessary to re-establish handheld-to-base unit communications, the following Associate
procedure must be performed.
Associate Handheld Remote to Base Unit
1. Remove power from the base unit.
2. Stand near the base unit in unobstructed, clear line-of-sight with the handheld in hand.
3. Simultaneously press and hold buttons B1 and B2. All LEDs activate.
4. Continue to hold both buttons until the TX LED begins flashing.
5. Apply power to the base unit while continuing to hold the buttons. All LEDs flash, then all
activate.
6. Release both buttons.
The SmaRT System is ready for use with that particular handheld remote.
4.5 Low Battery
At 3.5V the BAT LED begins flashing. Approximately 30 seconds later, the handheld shuts
down.
6
Figure 6. Associate Handheld Remote to Base Unit
WSMB-7588 JEM Technical
WSMB-7588_ESM 2-3