Toro 2024 Operator's Manual page 2

Safety
Improperly using or maintaining this equipment can
result in injury. To reduce the potential for injury,
comply with these safety instructions.Toro tested this
equipment for reasonably safe service; however, failure to
comply with the following instructions may result in personal
injury.
To ensure maximum safety, best performance, and
to gain knowledge of the product, it is essential that
you and any other operator read and understand the
contents of this manual before using this product. Pay
particular attention to the safety alert symbol
which means Caution, Warning, or Danger—"personal
safety instruction." Read and understand the instruction
because it has to do with safety. Failure to comply with
the instruction may result in personal injury.
•
Failure to abide by these precautions may result in
equipment failure and personal injury.
•
Use and maintain proper wiring. Improper, loose, and
frayed wiring can cause system failure, equipment damage,
and intermittent operation.
•
Changes or modifications made to equipment not
expressly approved by the manufacturer will void the
warranty.
•
Owner/operators of the equipment must abide by all
applicable Federal, State, and Local laws concerning
installation and operation of the equipment.
•
Make sure that the machinery and surrounding area is
clear before operating. Do not activate the remote control
system until certain that it is safe to do so.
•
Turn off the handheld remote and remove power from
the base unit before attempting any maintenance. This
will prevent accidental operation of the controlled
machinery.
•
Power is removed from the Base Unit by detaching the
12-pin cable from the base unit connector P1, or by
removing the source power from the circuit.
•
Use a damp cloth to keep units clean. Remove mud,
concrete, dirt, etc. after use to prevent obstructing or
clogging the buttons, levers, wiring, and switches.
•
Do not allow liquid to enter the handheld or base unit
enclosures. Do not use a high pressure washer to clean
the equipment.
•
Disconnect the radio base unit before welding on the
machine. Failure to disconnect the base unit may result in
destruction of or damage to the base unit.
•
Operate and store units only within the specified
operation and storage temperatures defined in this
document.
Setup
Installing the Receiver
Remove the panel on the control tower next to the operator's
seat (Figure
(Figure 1),
Remove the receiver that is currently installed and install the
new receiver as shown in
1. Receiver
2. Nuts
2
2).
Figure 2
Figure 3.
Figure 3
3. Bolts