Rwsc1U; Separate Type Signal Receiving Unit Installation - Panasonic CZ-24KPU1U Series Installation Instructions Manual

<CZ-RWSC1U>
CAUTION

5-12. Separate Type Signal Receiving Unit Installation

CAUTION
If local electrical codes allow, this signal receving
unit can be mounted using a conventional wall box
for fl ush mounting.
(1) If Wall mounted Fixed Position
Install the remote controller at a convenient
location on a nearby wall. However, before
attaching the remote controller mounting cradle,
check that the remote controller can operate from
the desired wall position. (Fig. 5-14)
How to Install Batteries
See Fig. 5-15.
(1) Press and slide the lid on the back of the remote
controller in the direction of the arrow.
(2) Install two AAA alkaline batteries. Make sure the
batteries point in the direction marked in the
battery compartment.
(3) Press the reset hole, then replace the lid. If you
press it, the current time, ON time, and OFF time
are all reset to 0:00.
Panasonic̲PAC-i̲IndoorUnit̲US-le46 46 Panasonic̲PAC-i̲IndoorUnit̲US-le46 46
If the signal receiving unit is installed near a rapid-start or inverter type fluorescent
lamp (neither one uses glow lamps), it may be impossible to receive signals from the
wireless remote controller. To avoid signal interference from fluorescent lamps, install
the receiving unit at least 6.6 ft. away from the lamps and install at a location where
wireless remote controller signals can be received when the fluorescent lamps are on.
Do not twist the operating
controller wires together
with the power supply
wires. Doing so can result
in malfunction.
If electrical noise is induced
in the unit power supply,
take appropriate measures,
for example installing a
noise fi lter.
Signal receiving unit
M4 × L1"
Screws (2)
L A
• L
R C U
S : U
B
P C
B C
H . K
E T
T S R
U N
R C
U : M
A N I
N O
R M L A
1 2 3
A D
R
4 5 6
Notch
Cover plate
Fig. 5-13
Fasten the remote control
mount with screws.
Remote control mount
Fig. 5-14
Fig. 5-15
46
Spacer
Switch box (no cover)
Fitting the remote
control in the mount.
2
Press
1 Put in
Reset hole
Cover
2011/11/02 15:17:35 2011/11/02 15:17:35