1
Important instructions for safety and environment
Your water dispenser must be
•
cleaned every 3 months in order
to prevent the contaminations
that might occur during the use.
You may get this done by our aut-
horized service agents for a fee.
When there is no water in the hot
•
water tank, do not turn the hea-
ting switch on.
After the transportation, the
•
cooling switch must be turned
off for the first four hours.
While using the product, do not
•
place a new bottle unless the
water in the bottle on the dispen-
ser is not completely finished.
This is required so that the water
level in the product remains ba-
lanced.
If there isn't a function appara-
•
tus on the lid of the water bottle,
make notches on the center of
the bottle lid with a sharp tool
(knife, etc.) in order to ease the
water intake into the tanks.
Place the water dispenser in a
•
shady area away from the elect-
ronics and valuables such as TV,
CD player or music system.
Do not operate the damaged
•
water dispenser. Consult the ser-
vice.
6 / 14 EN
Do not use drilling or cutting tools
•
on the rear parts where the refri-
gerant of the water dispenser is
circulating. The refrigerant that
might blow out when the gas
channels of the condenser or
pipe extensions are punctured
may cause skin irritations and eye
injuries.
Do not cover or block the product
•
with any material.
Flammable items or products that
•
contain flammable gases (e.g.
spray) as well as the explosive
materials should never be kept
near the appliance.
Do not tip the appliance at angle
•
of more than 45˚ during the trans-
portation or displacement.
Do not use the bottles that leak
•
water due to cracks, holes, etc.
In order not to damage the he-
•
ating system, never turn the he-
ating function on before water
comes out of hot water tap.
Do not turn the heating function
•
on when there isn't a water bottle
placed on the appliance.
Please drain the water in the drip
•
tray below the taps if they are fil-
led due to daily use.
Water Dispenser / User Manual