Toro Groundsmaster 360 Operator's Manual page 17

Hours
Counts
Diagnostics
Menu Item
PTO
Engine Run
Decks
Steer Mode
Machine Input
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Auto Idle
Only operator-faced text is translated. Faults, Service,
and Diagnostics screens are service-faced. The titles
are in the selected language, but the menu items are
in English.
About
Menu Item
Model
Lists the total number of hours
that the machine, engine, and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due
Lists numerous counts the
machine has experienced
Description
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit
Indicates the inputs, qualifiers,
and outputs for starting the
engine
Indicates the inputs, qualifiers,
and outputs for lifting and
lowering the deck
Indicates the inputs, qualifiers,
and outputs for switching
between 2-wheel steer and
4-wheel steer
Indicates the state of other
machine inputs such as
accessories and A/C clutch
Description
Controls the units used on the
InfoCenter; The menu choices
are English or Metric.
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary
Description
Lists the model number of the
machine
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
Auto Idle time delay and Stationary Regeneration;
refer to Accessing the DPF Regeneration Menus
(page 34). You can lock these settings by using the
Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
17
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
M , use the center button to
ENU
M and press the
ETTINGS ENU
10).
Figure 10
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 11A).
g028523