Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 360 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours Grease the bearing
and bushing grease fittings more
frequently in extremely dusty and
dirty conditions.
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Lubricate
the grease fittings immediately after every washing,
regardless of interval specified.
1. Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing
2. Pump the grease into the fittings.
3. Wipe off any excess grease.
Figure 66
Shown with cutting unit installed
49
(Figure 66).
g278285