Toro LT-F3000 Series Installation Instructions Manual page 3

2
Installing the Rear Lights
Parts needed for this procedure:
2 Bolt (M16 x 110 mm)
2 Locknut (M16)
1 Left light bracket assembly
1 Right light bracket assembly
1 Number-plate bracket
1 Number plate light
6 Washer (M6)
4 Locknut (M6)
2 Hex-head screw (M6 x 20 mm)
2 Setscrew (M3 x 16 mm)
2 Washer (M3)
2 Locknut (M3)
1 Pressure switch
2 Rear-light connector
1 Flasher relay
1 Fuse (10 amp)
1 Fuse (15 amp)
1 Dowty seal
1 Pressure-switch connector
1 Setscrew (M6 x 30 mm)
Mounting the Lights
WARNING
Using a drill without proper eye protection may
allow debris to enter the eye, causing injury.
When drilling or carrying out other operation,
always wear eye protection.
1. Open the engine cover.
2. Lift the platform.
3. Remove the bulkhead behind the operator's seat by
unscrewing the 4 bolts and 4 washers
the washers and 2 bolts.
Note: This is enables access to the main wiring loom.
4. Disconnect the negative cable from the battery.
5. Ensure that the ROPS pivot bolts and clamp bolts are
6. Remove the ROPS pivot bolt and locknut on the left
7. Align the hole in the left light bracket assembly with
8. Install the locknut (M16) on the bolt using the existing
(Figure 1). Retain
1. Bolt
2. Left light bracket assembly
3
Figure 1
in place and tight.
side of the machine.
this hole and insert the new bolt
washers, and tighten it to a torque of 15 N∙m (11 ft-lb).
Note: Do not overtighten the locknut, as this makes
the ROPS difficult to fold.
Figure 2
(Figure 2).
3. Locknut