Toro LT-F3000 Series Installation Instructions Manual page 6

1. Black wire
8. Connect the number plate light to the connector leads.
Refer to Figure 3.
9. Connect the other end of the connector lead to the
main loom connector located on the electrical mount
panel.
10. Plug the flasher relay into the vacant relay socket
located on the right side of the electrical mount panel.
Installing the Pressure Switch
Note: The pressure switch controls the brake lights.
1. Locate the rear face of the transmission manifold.
There is a port, marked "PS", fitted with a blanking
plug (Figure 10).
Figure 10
1. Transmission manifold
2. "PS" port
3. Dowty seal
2. Remove the blanking plug
3. Attach the pressure switch to the block using a dowty
seal and torque to 34 N∙m (25 ft-lb).
4. Attach the pressure-switch connector to the main
wiring loom.
5. Install the pressure-switch connector to the pressure
switch (Figure 10).
Figure 9
2. Red wire
4. Pressure switch
5. Pressure-switch connector
6. Blanking plug
(Figure 10).
3
Installing the Front Lights
Parts needed for this procedure:
1 Left bracket
1 Right bracket
1 Light frame assembly
2 Headlamp
2 Headlamp cable
4 Washer (M8)
4 Washer (5/16 inch)
4 Locknut (M8)
4 Hex-head screw (M8 x 25 mm)
2 Front light connector
8
Washer (M12)
4 Locknut (M12)
4 Hex-head screw (M12)
Installing the Brackets and the Lights
1. Install the left and right light supports to the front of
the machine using 8 washers (M12), 4 locknuts (M12),
and 4 hex-head screws (M12) as shown in
1. Locknut (M12)
2. Washer (M12)
3. Right light support
2. Install the front light bracket assembly to these
supports using 4 washers (M8), 4 washers (7/8 inch), 4
6
Figure
Figure 11
4. Left light support
5. Hex-head screw (M12)
11.