Toro LT-F3000 Series Installation Instructions Manual page 4

Note: If a beacon kit is fitted to the machine, you may
still use the pivot bolt location.
9. Feed all electrical cables down the front of the ROPS
frame and onto the electrical mount panel.
10. Connect the connector lead to the main wiring loom
of the machine (Figure
11. Connect 1 black and green connector to the rear
indicator light connector and the black, red, and orange
connector to the stop/tail light connector
Figure 3
View on cable entry
1. Connector lead
2. Black and red connector
3. Black and green connector 7. Stop/tail light connector
4. Black, red, and orange
connector
12. Repeat this procedure for the right side of the machine.
3).
(Figure
5. Number plate connector
6. Indicator light connector
Installing the Fuses and the Number
Plate
WARNING
When drilling or carrying out other operations,
always wear eye protection.
1. Install the fuses (10 and 15 A) beneath the horn as
shown in Figure
3).
1. Fuse (10 amp)
4
4.
Figure 4
2. Fuse (15 amp)