Table of Contents
Advertisement
● When this function is set to "ON":
"AUTO TIMER"
The timer recording standby mode is automatically engaged when the VCR is turned
"ON"
off. It is temporarily canceled when the VCR is turned on. You do not have to press
"OFF"
[TIMER (‰)] to engage or disengage the timer recording standby mode.
● When this function is set to "OFF":
You have to press [TIMER (‰)] to engage or disengage the timer recording standby
mode.
"SUPERIMPOSE"
When this function is set to "ON", various VCR status information (on-screen display)
"ON"
appears on the screen.
"OFF"
NOTES:
● When you use this VCR as the playback VCR for editing a tape, be sure to set this function to
"OFF"; otherwise, the VCR status information (on-screen display) will be recorded on the edited
tape.
● If you select a channel on which no signal is received, the channel number is displayed
regardless of this function setting.
"AUTO SP = EP
When this function is set to "ON", the VCR automatically switches to EP mode to allow
TIMER"
complete recording if there is not enough tape to record the entire program while timer-
(S-VHS/VHS only)
recording in SP mode.
"ON"
For Example . . .
"OFF"
Recording a program of 140 minutes in length onto a 120-minute tape
Make sure you set this function to "ON" before the timer-recording starts.
NOTES:
● If you have programmed the VCR to timer-record 2 or more programs, the second program and
those thereafter may not fit on the tape with this function set to "ON". In this case, do not use
this function, but change the recording speed manually during timer programming.
● In order to ensure that the recording fits on the tape, this function may leave a slight non-
recorded portion at the end of the tape.
● There may be some noise and sound disturbance where the recording speed switches from SP to
EP mode on the tape.
● This function is not available during ITR (Instant Timer Recording), and will work properly on the
following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
"VIDEO STABILIZER"
When this function is set to "ON", you can correct vertical vibrations in the picture
when playing back unstable recordings made on another VCR.
(S-VHS/VHS only)
"ON"
NOTES:
"OFF"
● When you finish viewing a tape, be sure to set this function to "OFF".
● Regardless of the setting, this function has no effect during recording and during special effects
playback.
● To watch recordings with close-caption, set this function to "OFF".
● When this function is set to "ON", the vertical vibrations may occur. Press [CHANNEL +] or [– ]
on the VCR (or [TV/VCR CH +] or [–] on the Remote) to eliminate vibration.
When this function is set to "ON", the VCR changes the screen into the blue back
"BLUE BACK"
screen automatically when receiving a channel not in use.
"ON"
"OFF"
When this function is set to "ON";
"2ND AUDIO RECORD"
● If a SAP program is received, the SAP audio is recorded on both the normal and Hi-Fi
"ON"
tracks. The main audio is not recorded.
"OFF"
● If a non-SAP program is received, the main audio is recorded on both the Hi-Fi and
normal tracks.
When this function is set to "OFF", the SAP audio cannot be recorded.
* The default setting is bold in the table below.
Approximately 110 minutes
SP mode
EN
Approximately 30 minutes
EP mode
CONTINUED ON NEXT PAGE \
37
Advertisement
Table of Contents
