Jlip Id Number Setting - JVC HM-DB1U Instructions Manual

JLIP ID Number
Setting
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the [VCR/TV/CABLE/DBS] selector on the
Remote to [VCR].
VCR
CABLE
TV /DBS
4
1 2
4 5
7 8
0
1 5
3
6
9
2 - 4
The JLIP (Joint Level Interface Protocol) terminal is used
to connect the VCR to a personal computer or similar
device. By connecting through the JLIP terminals, you
can control the VCR during editing and certain other
operations, from the connected personal computer or
similar device.
When connecting this VCR to another device using the
JLIP terminals, each device must have a different JLIP ID
number.
The JLIP ID number of this VCR is preset to "1" when
shipped from the factory. You can change this number to
any other number between 1 to 99.
To change the JLIP ID number of this VCR, follow the
procedure below.
1
Access Main Menu screen
Press [MENU].
2
Access Initial Set screen
Press [%fi] to move the highlight bar (arrow) to
"INITIAL SET", then press [OK] or [#].
3
Select JLIP ID No. Set screen
Press [%fi] to move the
highlight bar (arrow) to
"JLIP ID NO. SET", then
press [OK] or [#].
4
Set JLIP ID Number
Press the 'Number' keys
to enter the desired ID
number, then press [OK]
or [#].
5
Return to normal screen
Press [MENU].
NOTE:
For further details on the JLIP system or devices, consult your
nearest JVC dealer.
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
39
EN
INITIAL SET
CLOCK SET
JLIP ID NO. SET
SELECT WITH( , ) AND(OK)
PRESS(MENU) TO END
JLIP ID NO. SET
1
PRESS NUMBER KEY(0-9)
THEN (OK)
PRESS(MENU) TO END