c
Installing Service Boards
NOTE
•
The following describes how to install boards in upper slots. The installation direction of boards in lower
slots is opposite.
•
When installing boards, ensure that there is no vacant slot. Other slots must be installed with boards or
filler panels.
Remove the filler panel screws and hold the
ejector levers outwards. Then withdraw the filler
panel from the slot.
Push the ejector levers inwards to secure the board
in the slot.
Guide rail
Hold the ejector levers outwards until a maximum
angle is formed between the ejector levers and the
front panel. Then, gently slide the board along the
guide rails into the slot until the board is fully
seated in the slot.
Tighten the screws on the front panel of the board.
49
M4
2# screwdriver
0.71 ± 0.07 N· m