Installing/Routing Fibers; Precautions And Open-End Corrugated Pipe Introduction - Huawei OptiX OSN 9800 U32 Enhanced Subrack V100 Quick Installation Manual

Installing/Routing Fibers

11.1

Precautions and Open-End Corrugated Pipe Introduction

Precautions
No.
1 Avoid direct eye exposure to fiber connectors when performing operations such as installing and maintaining fibers.
The bending radius of G.657B3 fibers must not be less than 8 mm, consult the Installation Reference for the
2
bending radius.
After installing fibers, insert a fiber plug into each unconnected optical port and cap the unused connector on each
3
fiber patch cord.
When routing and installing fibers onsite, you need to clean fiber end faces.
For detailed operations, see the multimedia at the following website:
http://support.huawei.com/carrier/docview!docview?nid=DOC1000132657
4
Open-End Corrugated Pipe Introduction
corrugated pipes
NOTE
•Do not use an open-end corrugated pipe to hold excessive fibers. It is recommended that an open-end
corrugated pipe that has a diameter of 32 mm accommodate 60 fibers at most, each with a diameter of 2
mm.
•Before routing fibers out of a cabinet, ensure that they are protected in an open-end corrugated pipe and
about 10 cm of the open-end corrugated pipe is inside the cabinet.
•When an A63B cabinet uses corrugated pipes to protect optical fibers, 360 optical fibers can be routed on
one side at the top of the cabinet, and a total of 720 optical fibers can be routed.
Winding pipe
NOTE
•When an A63B cabinet uses winding pipes to protect
optical fibers, 720 optical fibers can be routed on one side
at the top of the cabinet, and a total of 1440 optical fibers
can be routed.
Optical fiber protection using corrugated pipes
Precautions
Scan the QR code to view multimedia documents.
Optical fiber protection using winding pipes
71
Winding pipe