Cutting Unit; Clutch, Clutch Drum And Gearbox - Husqvarna 322HD60 Workshop Manual

7.10.4 To remove and install the stop switch
1. Use a flat screwdriver to loosen the stop switch.
2. Disconnect the 2 cables.
3. Remove the stop switch.
4. Install in the opposite sequence.

7.11 Cutting unit

7.11.1 To remove and install the cutting unit
1. Remove the front handle. Refer to
install the front handle on page 27 .
2. Remove the throttle handle. Refer to
install the throttle handle on page 27 .
30 - Repair instructions
3. Remove the 3 screws (A).
4. Remove the 2 screws (B).
5. Remove the cutting unit (C).
6. Clean the cutting unit.
7. Examine the cutting unit for damage and wear.
8. Examine the sharpness of the blades. Sharpen the
9. Install in the opposite sequence.

7.12 Clutch, clutch drum and gearbox

7.12.1 To disassemble and assemble the clutch
1. Remove the throttle handle. Refer to
To remove and
2. Remove the front handle. Refer to
To remove and
3. Remove the cutting unit. Refer to
4. Remove the spark plug.
5. Put the piston stop in the spark plug hole. Refer to
6. Put the product with the starter unit down.
A
C
WARNING: Use protective gloves.
Replace damaged parts.
blades if it is necessary.
install the throttle handle on page 27 .
install the front handle on page 27 .
install the cutting unit on page 30 .
Servicing tools on page 10 .
B
To remove and
To remove and
To remove and
1369 - 001 - 13.02.2020