Crankshaft And Crankcase - Husqvarna 322HD60 Workshop Manual

5. Put a new cylinder base gasket on the crankcase.
CAUTION: Make sure that the cylinder base
gasket does not have signs of damage and
wear.
6. Install the support plate from the piston assembly kit.
38 - Repair instructions
7. Use the clamp from the piston assembly kit to
compress the piston ring. Carefully push the piston
into the cylinder opening. Tighten the 2 screws to
the specified torque. Refer to
6 .
8. Install the remaining parts in the opposite sequence.

7.14 Crankshaft and crankcase

7.14.1 To get access to the crankcase and
crankshaft
1. Do step 1-13 in To remove the cylinder and piston
on page 33 .
2. Remove the ignition module, if it is attached.
Servicing data on page
1369 - 001 - 13.02.2020