Prepare And Do Servicing On The Product; Maintenance Schedule - Husqvarna 322HD60 Workshop Manual

3 Prepare and do servicing on the product

3.1 Maintenance schedule

Maintenance
Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting attachment does not move at idle speed.
Do a check of the stop switch.
Examine the cutting attachment and the cutting attachment guard for damages
and cracks. Replace if it is damaged.
Examine the hand guard for damages and cracks. Replace if it is damaged.
Do a check of the throttle trigger lockout and the throttle trigger.
Examine the engine, the fuel tank and the fuel lines for leaks.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if necessary.
Examine the starter and the starter rope for damages.
Clean the air filter. Replace if it is necessary.
Examine the vibration damping units for damages and cracks.
Examine the spark plug, refer to
Clean the cooling system.
Clean the external surface of the carburetor and the area around it.
Clean or replace the spark arrester mesh.
Clean the inner surface of the fuel tank.
Examine the spark plug.
Make sure that the gear housing is filled with grease.
1369 - 001 - 13.02.2020
To examine the spark plug on page 20 .
Before After 100
After 40 h
operation
After each operation.
After each operation.
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Prepare and do servicing on the
product - 5
h
X
X
X
X