Table of Contents
Advertisement
spacer. Exercise care on assembly to avoid damaging
the lead.
After flitting the armature plate n the crankcase it will
be necessary to set the timing, Rotate the plate until the
mark on the crankcase and the line inscribed on the ar-
mature plate are opposite each other (ignition system
SEM G6/35E see Fig. 510).
Tighten the screws securing the armature plate. Fit the
flywheel (note the key slot) and other components In re-
verse order to removal.
Use special pliers No 502 50 06-01 when fitting the
sparking plug cap to the plug lead to ensure satisfactory
connection between contact spring and lead.
We recommend applying grease No 502 50 42-01 to
both ends of the plug lead where it is connected to the
sparking plug cap and the ignition coil. In the latter case
the grease should be packed under the rubber cover.
5:3
Hide quick links:
Advertisement
Table of Contents
