Silvercrest SZP 25 B1 Operating Instructions Manual page 6

__RP93143_B6.book Seite 4 Montag, 17. Juni 2013 11:24 11
DANGER! Risk of electric
shock due to moisture
• Protect the base of the device against
moisture, drips and splashes.
• The base, the power cable and the
mains plug must not be immersed in wa-
ter or any other liquids.
• If liquid gets into the base, immediately
pull out the mains plug. Have the device
checked before reusing.
DANGER! Risk of electric
shock
• Do not use the device if the device or the
power cable has any visible damage, or if
the base has previously been dropped.
• Only connect the mains plug to a properly
installed and easily accessible wall socket
whose voltage corresponds to the specifi-
cations on the rating plate. The wall socket
must continue to be easily accessible after
the device is plugged in.
• Ensure that the power cable cannot be
damaged by sharp edges or hot points.
• The device is not fully disconnected from
the power supply, even after it is switched
off. In order to fully disconnect it, pull out
the mains plug.
• When using the device, ensure that the
power cable cannot be trapped or
crushed.
• To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
• Disconnect the mains plug from the wall
socket...
... if there is a fault,
... if you are not using the citrus press,
... before you assemble or disassemble
the citrus press,
... before you clean the citrus press and
... during thunderstorms.
• To avoid any risk, do not make modifi-
cations to the device. You also must not
replace the power cable yourself. Re-
4
GB
pairs must be carried out by a specialist
workshop or the Service Centre.
WARNING! Risk of injury by
turning parts
• Do not touch the rotating juicer cone di-
rectly. Do not touch rotating parts with
small spoons or similar utensils. Keep
long hair or loose clothing away from
rotating parts as well.
• Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
WARNING! Risk of material
damage
• Do not block and overload the motor.
Do not put excessive pressure on the
juicer cone.
• Ensure that no foreign body is on the
screen or in the device when operating it.
• In order to avoid damage to the device,
interrupt pressing immediately, if the
juicer cone is not turning or having diffi-
culty turning. Pull out the mains plug
and check if there is a foreign body in
the device.
• The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
• Place the device on a stable, flat surface.
• Never place the device on hot surfaces
(e.g. hot plates) or near heat sources or
open fire.
• Only use the original accessories.
• Do not clean the citrus press or any of
its accessories in the dishwasher or with
boiling hot water.
• Do not use any astringent or abrasive
cleaning agents.