Removing The Juice; Cleaning; Storage; Disposal - Silvercrest SZP 25 B1 Operating Instructions Manual

__RP93143_B6.book Seite 6 Montag, 17. Juni 2013 11:24 11
3. As soon as you stop pressing on the
juicer cone|2/3, the device stops.
4. If the juicer cone|2/3 is not turning,
check if there are pips between the juic-
er cone and the screen|4/5 and re-
move them, if necessary.

6.3 Removing the juice

CAUTION: pull out the mains plug|9 be-
fore removing the juice container|7 from the
base|10.
1. Figure B: turn the juice container|7
counterclockwise and lift it from the
base|10.
2. Pour the juice out of the juice container|7.
3. In order to remove pulp and pips, you
can remove the screens|4/5 and the
juicer cone|2/3 together with the juice
container|7.
4. Clean the device after each use as soon
as possible so the pulp does not start
drying to the surface.

7. Cleaning

Clean the device prior to its first use!
DANGER! Risk of electric
shock!
• Pull out the mains plug|9 from the wall
socket before cleaning the citrus press.
• The base|10, the power cable and the
mains plug|9 must not be immersed in
water or any other liquids.
WARNING!
• Do not clean the citrus press or any of
its accessories in the dishwasher or with
boiling hot water.
• Do not use any astringent or abrasive
cleaning agents.
6
GB
NOTE: clean the device after each use as
soon as possible so the pulp does not start
drying to the surface.
1. Remove the lid|1, if necessary.
2. Remove the juicer cones|2/3 and disas-
semble them.
3. Remove the screens|4/5.
4. Figure A: in order to disassemble the
screens|4/5, exert slight pressure on
the screen opener|6.
5. Figure B: turn the juice container|7
counterclockwise and lift it from the
base|10.
6. Wipe the base|10 with a damp cloth.
7. Wash up all removable accessories by
hand. Make sure to wash the small cavi-
ty in the handle with a sufficient amount
of clear water.
8. Dry all parts carefully, before reassem-
bling the device and storing it.

8. Storage

1. You can wind up the power cable|9 in
the cable wrap|11.
2. Place the lid|1 on the device as a pro-
tection against dust. Ensure that the re-
cess in the edge of the lid is above the
handle.

9. Disposal

The symbol showing a wheel-
ie bin crossed through indi-
cates that the product requires
separate refuse collection in
the European Union. This ap-
plies to the product and all ac-
cessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.