Epson L565 Service Manual page 49

L565/L566 Series
Step 1-2
Hole of
Frame Base
Pump
Tube A
Route Pump Tube A through ribs of Frame
Base with their dashed line facing upward.
Frame Base
When installing the Pump Unit, follow the procedure below in order to prevent ink suction failure.
1. Route the Pump Tube A through the hole of the Frame Base.
2. Install the Pump Unit to the Frame Base, and route the Pump Tube A through the ribs of the Frame Base with their dashed line facing upward.
3. Secure the Pump Unit to the Frame Base with the screw (x1).
4. Route the Pump Tube B through the ribs of the Pump Unit and Frame Base, and insert it to the hole of the Frame Base up to the marking
(8 ± 1 mm from tube end).
Spur gear / Extension Spring 0.137 /
Clutch / LD Roller shaft
Spur gear
Clutch
Extension Spring 0.137
LD Roller Shaft
LD Roller
Install Spur gear/Extension Spring 0.137/Clutch/LD Roller shaft as
shown in the figure above.
Disassembly/Reassembly
Pump Unit
Step 4
Pump Unit
Step 3
Marking
Hole of Frame Base
Insert Pump Tube B up to the marking (8 ± 1 mm
from tube end) to the hole of Frame Base.
C.B.P-TITE SCREW 3x10 F/ZN-3C (6 ± 1 kgf·cm)
PF Grounding Spring
Left PF Grounding
Spring
Cutout
Spring leg B
Spring leg B
Main Frame
Frame Base
Assy
When installing the PF Grounding Spring, follow the procedure below.
1. From the left side of the printer, insert the spring leg A of the
PF Grounding Spring into the hole of the Frame Base.
2. Insert the spring leg B of the PF Grounding Spring into the
groove of the Frame Base.
3. Attach the spring leg B of the PF Grounding Spring to the
cutout of the Main Frame to install the PF Grounding Spring.
Detailed Disassembly/Reassembly Procedure for each Part/Unit
Rear of printer
Pump
Tube B
8 ± 1 mm
Rib
Install the LD Roller Assy with the following condition in order to avoid the Change Lever and Paper Back Lever.
Using a screw driver or the like, hold the Paper Back Lever to the rear as shown above not to let it touch the LD Roller Assy.
Push the Change Lever to the front to keep it in the hole of the Main Frame.
Top Cover
Spring leg A
PF Grounding
Spring
Insert spring leg
A into groove.
Hole
When attaching the Top Cover Label, align it with the markings on
the Top Cover as shown in the figure above.
LD Roller Assy
Change Lever
Cam
Paper Back Lever
LD Roller Assy
Top Cover Label
Color position
Color indication on Ink Tank is deleted. Color position is
specified on Top Cover.
Top Cover
Revision A
Main Frame
Top Cover
No color position
49
Confidential