Epson L565 Service Manual page 51

L565/L566 Series
Bottom Cover / Left Cover / Right Cover / Cover Joint
Left Cover
Bottom Cover
3 5 6 4
1
C.B.P-TITE SCREW 3x6 F/ZN-3C (4 ± 1
Be careful about how to place the Ink Supply Tank Assy in order to prevent printing failure from occurring. (See
.)
Disassembling (p27)"
The figures above indicate the hooks and ribs that secure the parts.
Remove the exterior parts of the Ink Supply Tank Assy in the following order.
1. Remove the screws (x6) of the Bottom Cover, and remove the Bottom Cover.
2. Remove the Left Cover and Right Cover.
3. Remove the Cover Joint.
Tighten the screws in the order indicated in the figure above.
Disassembly/Reassembly
Cover Joint
Ink Supply Tank Assy
Hook
Rib
2
"2.1.5Checks and Precautions before
Detailed Disassembly/Reassembly Procedure for each Part/Unit
Joint
Ink Supply Tube
Ink Supply Tube Guide 2nd
When attaching the Joint, align the cutout of the Joint with the rib of the Ink Supply Tube Guide 2nd.
Make sure the gaps between the end of Ink Supply Tank Tubes or Ink Supply Tubes and the Joint are 0.5 mm long or less.
Right Cover
Ink Supply Tube Guide 2nd
Tube Guide Sheet
Refer the figure above and follow the procedure below when attaching the Tube Guide Sheet Sub to the Tube Guide Sheet.
1. Insert the section A of the Tube Guide Sheet Sub into the hole 1 of the Tube Guide Sheet from the bottom.
2. Insert the section A of the Tube Guide Sheet Sub into the hole 2 of the Tube Guide Sheet from the top.
When attaching the Tube Guide Sheet to the Ink Supply Tube Guide 2nd, while keeping the Tube Guide Sheet Sub attached on the Tube Guide
Sheet, align the holes of the Tube Guide Sheet with the protrusions of the Ink Supply Tube Guide 2nd.
Joint
Ink Supply Tube
Joint
Rib
Tube Guide Sheet / Tube Guide Sheet Sub
Tube Guide Sheet
Hole 1
Cross Section
OK
Hole 1
NG
Revision A
0.5 mm or less
Joint
0.5 mm or less
Ink Supply Tank Tube
Cutout
Hole 2
Tube Guide Sheet Sub
Section A
Tube Guide Sheet
Tube Guide Sheet Sub
Hole 2
Tube Guide Sheet
51
Confidential