Table of Contents
Advertisement
EN
6.2. Cleaning
To clean the BEKOMAT
, use a damp (but not wet) cotton cloth or disposable tissue and a mild conventional detergent.
®
Spray a little detergent onto the clean cotton cloth or tissue and carefully wipe the component. Dry the device with a clean cloth
or let it dry at room temperature. Observe all hygiene instructions applicable on the site.
NOTICE
Damage caused by improper cleaning
Cleaning with a wet cloth, pointed implement or aggressive detergent can cause damage to the
device components and integrated electronic components.
•
•
•
Cleaning
A. Cleaning container:
Do not actuate the test switch, but:
•
Close inlet
•
Carefully open manual drain at
container
•
Residual pressure flushes container
B. Cleaning sensor tube:
•
Remove the flange at the top of the
container (loosen hose connector,
cable plug and flange screws; lift
flange with electronic assembly and
sensor tube from the container)
•
Clean only the outside of the sensor
tube, not the inside
•
Reassemble and install the flange
C. Cleaning valve:
Do not attempt to open the screws
marked in colour! The coloured
screws are factory-set and must not be
interfered with!
BEKOMAT
8/9
®
Never clean the device with a wet cloth.
Do not use aggressive detergents.
Do not clean or operate the device with hard or pointed implements.
B
A
Installation and operating manual
C
21
Advertisement
Table of Contents
