Toro 04651 Operator's Manual page 12

Figure 14
1. Bedbar bolt
4. Remove each bedbar bolt allowing the bedbar
to be pulled downward and removed from the
cutting unit (Figure
Account for the 2 nylon washers and 1 steel
washer on each end of the bedbar
Figure 15
1. Bedbar bolt
2. Steel washer
2. Locknut
14).
(Figure
3. Nut
4. Nylon washer
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washers and the bedbar-adjusting
screw (Figure
2. Secure the bedbar to each side plate with the
bedbar bolts (nuts on bolts) and 3 washers (6
total).
3. Position a nylon washer on each side of the
side-plate boss. Place a steel washer outside
g014409
each of the nylon washers
4. Torque the bedbar bolts to 27 to 36 N∙m (240 to
320 inch-lb).
5. Tighten the locknuts until you remove the end
play from steel washers, but you are able to
rotate them by hand. The washers on the inside
may have a gap.
Important:
15).
or they will deflect the side plates.
6. Tighten the spring tension nut until the spring is
collapsed, then back it off 1/2 turn
g020056
1. Spring-tension nut
7. Adjust the bedknife to the reel; refer to
the Bedknife-to-Reel Contact (page
12
13).
(Figure 15).
Do not overtighten the locknuts
(Figure
Figure 16
2. Spring
16).
g016470
Adjusting
6).