Toro 04651 Operator's Manual page 9

Low-cut 93-4264
(Optional)
High-cut 94-6392
(Optional)
Fairway 63-8610
(Optional)
Fairway 137-0879
EdgeMax
(optional)
Note:
For heights of cut greater than 9.5 mm (0.375
inch), install the high-height-of-cut kit.
Adjusting the Height-of-Cut Gauge
Before adjusting the height of cut, set the height-of-cut
gauge as follows:
1. Loosen the nut on the gauge bar and set the
adjusting bolt to the desired height of cut
8).
Note:
The distance between the bottom of the
bolt head and the face of bar is the height of cut.
1. Gauge bar
2. Height-adjusting bolt
2. Tighten the nut.
Adjusting the Height of Cut
1. Loosen the locknuts securing the height-of-cut
arms to the cutting-unit side plates
4.7 to 25.4 mm (0.188 to
1.00 inch)
7.9 to 25.4 mm (0.312 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
9.5 to 25.4 mm (0.375 to
1.00 inch)
Figure 8
3. Nut
(Figure
(Figure
1. Height-of-cut arm
2. Flange locknut
2. Hook the bolt head of the height-of-cut gauge
onto the right side of the cutting edge of the
bedknife and rest the rear end of the bar onto
the rear of the roller
g000489
1. Gauge bar
9).
3. Rotate the adjusting bolt until the roller contacts
the front of the gauge bar.
4. Repeat steps
5. Adjust both ends of the roller until the entire
roller is parallel to the bedknife.
Important:
and front rollers will contact the gauge
bar and the bolt will be snug against the
bedknife. This ensures that the height of cut
is identical at both ends of the bedknife.
6. Tighten the nuts to secure the adjustment
enough to remove play from the washer.
9
Figure 9
3. Adjusting bolt
(Figure 10).
Figure 10
2 and 3 for the left side.
When set properly, the rear
g278333
g014408