Toro 04651 Operator's Manual page 8

Note:
If excessive contact/reel drag is evident,
backlap, reface the front of the bedknife, or grind
the cutting unit to achieve the sharp edges needed
for precision cutting (Refer to the Toro Manual for
Sharpening Reel and Rotary Mowers, Form No.
09168SL).
Adjusting the Rear-Roller Height
Depending on your desired height-of-cut range, you
need to adjust the rear-roller brackets
Figure 7) to the low or high position:
•
Position the spacer above the sideplate-mounting
flange (factory setting) when the height-of-cut
settings range from 1.5 mm to 6 mm (1/16 inch to
1/4 inch) as shown in
1. Spacer
2. Sideplate-mounting flange
•
Position the spacer below the sideplate-mounting
flange when the height-of-cut settings range from
3 mm to 25 mm (1/8 inch to 1 inch) as shown in
Figure 7.
Figure 5
(Figure 6
Figure 6.
Figure 6
3. Roller bracket
1. Sideplate-mounting flange
2. Spacer
g014411
1. Raise the rear of the cutting unit and place a
block under the bedknife.
2. Remove the 2 nuts securing each roller bracket
and spacer to each sideplate mounting flange.
3. Lower the roller and bolts from the sideplate
mounting flanges and spacers.
4. Place the spacers onto the bolts above or below
the roller brackets, as required
Figure 7).
5. Secure the roller bracket and spacers to the
or
underside of the mounting flanges with the nuts
previously removed.
Note:
The position of the rear roller to the reel
is controlled by the machining tolerances of the
assembled components and paralleling is not
required.
Adjusting the Height of Cut
Use the following chart to determine which bedknife is
best suited for the desired height of cut.
Bedknife
Edgemax
Micro-cut
(Standard)
Edgemax
g014404
Tournament
(Optional)
Micro-cut
(Optional)
Tournament
(Optional)
Extended
Micro-cut
(Optional)
Extended
Tournament
(Optional)
8
Figure 7
3. Roller bracket
(Figure 6
Part No. Height-of-Cut
115-1880 1.5 to 4.7 mm (0.062 to
0.188 inch)
115-1881 3.1 to 12.7 mm (0.125 to
0.500 inch)
93-4262 1.5 to 4.7 mm (0.062 to
0.188 inch)
93-4263 3.1 to 12.7 mm (0.125 to
0.500 inch)
108-4303 1.5 to 4.7 mm (0.062 to
0.188 inch)
108-4302 3.1 to 12.7 mm (0.125 to
0.500 inch)
g014405
or