Table of Contents
Advertisement
Figure 23
1. Flange-head bolt (5/16 x
2-1/4 inches)
2. Small washer
17.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 2-1/4
inches), 2 small washers, and a spacer
23). Position a washer on each side of the
sunshade-rubber grommet. Position the spacer
between the bottom small washer and the frame.
18.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
g021308
3. Sunshade
4. Spacer
(Figure
Installing the Sunshade
Groundsmaster 4500 and 4700
Machines or Reelmaster 6700 and
7000 Machines
Important:
Installation kit (Part No. 136-1830) is
required for Groundsmaster 4500 and 4700 with
serial number 400000001 and higher.
1.
To properly align the frame, attach the
frame-alignment bar to the mounting tabs on the
rear of the sunshade frame with 2 flange-head
bolts (5/16 x 1-1/4 inches) as shown in
24.
1. Sunshade frame
2. Frame-alignment bar
3. Flange-head bolt (5/16 x
1-1/4 inches)
2.
For Groundsmaster 4500 and 4700 machines
with serial number 400000001 and higher,
continue as follows; for all other machines,
proceed to step 3.
A.
With the roll bar in the raised position,
remove the hairpin cotter and pin
14
Figure 24
4. Mounting tab
5. Retainer nut
Figure
g020204
Advertisement
Table of Contents
