Table of Contents
Advertisement
11.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
12.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches) and 2 small washers
Note:
Position a washer on each side of the
sunshade-rubber grommet.
13.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Figure
Figure 4
3. Sunshade
(Figure
4).
Installing the Sunshade
4.
Groundsmaster 3280 Machine
1.
To properly align the frame, attach the
frame-alignment bar to the mounting tabs on the
rear of the sunshade frame with 2 flange-head
bolts (5/16 x 1-1/4 inches) as shown in
g017923
1. Sunshade frame
2. Frame-alignment bar
3. Flange-head bolt (5/16 x
1-1/4 inches)
2.
With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins
1. Roll bar
2. Pin
7
Figure
Figure 5
4. Mounting tab
5. Retainer nut
(Figure
Figure 6
3. Hairpin cotter
5.
g020204
6).
g001199
Advertisement
Table of Contents
