Table of Contents
Advertisement
15.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 10
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
16.
Loosely mount each corner of the sunshade
to the frame with a flange-head bolt (5/16 x
1-1/4 inches) and 2 small washers
Position a washer on each side of the sunshade
rubber grommet.
17.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Figure
g020025
3. Sunshade
(Figure
10).
Installing the Sunshade
10.
Groundsmaster 360 or 7200
Machines
1.
To properly align the frame, attach the
frame-alignment bar to the mounting tabs on the
rear of the sunshade frame with 2 flange-head
bolts (5/16 x 1-1/4 inches) as shown in
1. Sunshade frame
2. Frame-alignment bar
3. Flange-head bolt (5/16 x
1-1/4 inches)
2.
With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins
9
Figure
Figure 11
4. Mounting tab
5. Retainer nut
(Figure
11.
g020204
12).
Advertisement
Table of Contents
