Table of Contents
Advertisement
11.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 33
1. Flange-head bolt (5/16 x
2-1/4 inches)
2. Small washer
12.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 2-1/4
inches), 2 small washers, and a spacer
33). Position a washer on each side of the
sunshade-rubber grommet.
13.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Figure
g021308
3. Sunshade
4. Spacer
(Figure
Installing the Sunshade
33.
Reelmaster 3100 and 3550
Machines or Groundsmaster 3500
and 3505 Machines
(Serial #400000000 and up only)
1.
To properly align the frame, attach the
frame-alignment bar to the mounting tabs on the
rear of the sunshade frame with 2 flange-head
bolts (5/16 x 1-1/4 inches) as shown in
34.
1. Sunshade frame
2. Frame-alignment bar
3. Flange-head bolt (5/16 x
1-1/4 inches)
2.
On each side of the sunshade frame, loosely
mount a brace to the third hole of the brace
bracket with a bolt (1/2 x 2-1/2 inches), washer
(1/2 inch), and flange nut (1/2 inch) as shown
in
Figure
35.
1. Bolt (1/2 x 2-1/2 inches)
2. Washer (1/2 inch)
3. Brace
4. Front hole
5. Flange nut (1/2 inch)
18
Figure 34
4. Mounting tab
5. Retainer nut
Figure 35
6. Second hole
7. Third hole
8. Rear hole
9. Brace bracket
Figure
g020204
g035754
Advertisement
Table of Contents
