Checking The Disk Connection State Before Mounting The Built-In Disk - Fujitsu PRIMEQUEST 2000 Series Manual

Consideration of Linux Installation
5.2 Using built-in disk with Linux
To use the built-in disk, you need make a setting in the UEFI so that the following disk is recognized first as the
start disk: disk with which the SAN boot environment is configured on the SAN storage unit machine.
Therefore, after installing the operating system, perform the following additional steps to use the built-in disk.
Note: All screenshots appearing below are display examples whose contents vary depending on the system configuration,
etc.

5.2.1 Checking the disk connection state before mounting the built-in disk

Execute the following command while the partition is operating to check the current disk connection state.
# ls -l /dev/disk/by-id
5.2.2 Mounting the built-in disk
Use the following command to shut down the partition.
# shutdown -h now
After powering off the partition, mount the built-in disk.
5.2.3 Configuring the RAID of the built-in disk (when using the SAS array
disk unit)
Initialize the built-in disk inside a RAID configuration, for example, since the built-in disk will be recognized at the next
startup. For details on building a RAID configuration with the built-in hard disk, see the MegaRAID SAS User's Guide and
the MegaRAID SAS Device Driver Installation User Guide.
C122-E206-04EN
106