Configuring The Uefi - Fujitsu PRIMEQUEST 2000 Series Manual

Consideration of Linux Installation

5.2.4 Configuring the UEFI

Start the Boot Manager front page. Select [Boot Maintenance Manager] - [Boot Options]- [Change Legacy HDD Boot
Priority]. Then, assign the boot disk that was built on the SAN storage unit to the top position.
The procedure for making this setting is as follows.
Starting the Boot Manager front page
1. Power on the target partition.
2. After one or two minutes, the window shown below appears. Press any key ([Space] key, for example) other than the
[Enter] key while the FUJITSU logo is displayed.
FIGURE 5.3 Logo at startup
3. The Boot Manager front page appears. Use the down arrow key to select [Boot Maintenance Manager], which is the
option at the bottom. Press the [Enter] key.
C122-E206-04EN
107