Speed And Topology Settings - Fujitsu PRIMEQUEST 2000 Series Manual

Settings on the Fibre Channel Card (8Gbps FC Card)

2.1.7 Speed and Topology settings

The following describes how to make the Speed and Topology settings.
Note
Do not set [AUTO Loop First - default.] or [AUTO Point to Point first.]. First, make the fixed setting.
Otherwise, the connected device will not be normally recognized.
Static Topology setting
On the [Emulex Adapter Configuration Main Menu] screen, make the following setting that corresponds to the connection
pattern (Fabric connection/FCAL connection).
1. Select [Configure HBA and Boot Parameters], and then press the [Enter] key.
FIGURE 2.14 Static Topology setting (1)
2. Select [Topology Selection <AUTO Loop First –default>], and then press the [Enter] key.
FIGURE 2.15 Static Topology setting (2)
C122-E206-04EN
22