Huawei ETS2000 Series Maintenance Manual page 49

HUAWEI ETS2000 系列 无线固定台 维修手册
Area Code Setting
##53*xxxxx#
1
##53*#
UIM Lock Setting***
##54*1*XXXX#
##54*2*XXXX#
1
##54*3#
prefix setting
##55*0#
##55*1#
1 ##55*2#
##55*3#
##55*4#
banlence display setting
##56*0#
1
##56*1#
Language Setting
##57*0#
1
##57*1#
Auto dial time Setting
1 ##58*n#
Access code Setting
1 ##59*n#
##59*1*n#
2 ##59*2*n#
##59*3*n#
NOTE: The keypad commands of area code setting are valid only when code
analyzing is NOT supported. So these two commands are invalid for the
following versions: through B055 to current version.
set an Area Code as xxxxx (5 digits at most)
erase the Area Code
DESCRIPTION: set or erase an Area Code, only valid in RUIM version
NOTE: The Function is Supported just when UIM function is Supported;
Lock the UIM. XXXX is PIN code.
Unlock the UIM. XXXX is SPC code.
Check the status of the UIM; If the UIM has been locked, there is a sound
of beep; if the UIM hasn't been locked, there are three sounds of beep;
if the check procedure has failed, there are two sounds of beep.
DESCRIPTION: When you check the UIM status ,"LOC" means the UIM is
locked, and "UNLOC" means the UIM is unlocked
NOTES: not all setting supported by all version
no prefix
local area number adding
access number adding for dialing-out
enable local area number adding and access number adding
enable long-distance and mobile access number
close intelligent network service charge display
enable intelligent network service charge display
DESCRIPTION: Enable/Cancel the Balance display
Setting language is English.
Setting language is Chinese.
Setting time to automatic dial. n = 0~9. 0: close. 1~9 is the time for
dial-out, unit second.
Setting the access code .（the version before BO5C）
DESCRIPTION: ##59*x*n# can only be used after B05C
Setting the access code .
Setting the long distance fix phone access code .
Setting the long distance mobile phone access code .
DESCRIPTION: Only valid when reset
49
第四章