Siemens SINUMERIK 840D Description Of Functions page 463

11.03
Cam synchronization SN1+
Channel 1 (NCK) - unsync. .
SN1+ (K1) + SAFE_CAM_TOL
&
SN1+ (K2 - channel 2)
Channel 2 (drive) - unsync.
SN1+ (K2) + SAFE_CAM_TOL
SGA SN1+ synchronized
with hysteresis
Generation of an area cam from SN1+ and SN1- (PULSE)
SGA SN1+ synchronized with hysteresis
(negation of a signal for SN1+ via MD parameters)
SGA SN1- synchronized with hysteresis
(generated in same way as SN1+)
Use of cam signals (signal pattern depending on traversing direction)
(by mapping onto same signal HW/INSI)
Traversing
direction +
Traversing
direction -
Fig. 8-12 Signal generation for modulo cam 2
As can be seen in the diagram, the setting of machine data
MD_SAFE_CAM_TOL determines the following variables:
•
•
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
SN1+ (K1- channel 1 )
.
SAFE_CAM_TOL
SAFE_CAM_TOL
Magnitude of the hysteresis (for a synchronized cam signal)
Magnitude of the traversing direction-dependent offset of the pulse
generated from two cam signals
8 Application examples
8.4 Safe cams at the modulo limit
SAFE_CAM_TOL
Static deviation of actual values
SAFE_CAM_TOL
SAFE_CAM_TOL
SAFE_CAM_TOL
SAFE_CAM_TOL
SN_Sync01_00.DSF
8-463