Installation Guide
Installing the HP G2614A Tray
Installing the HP G2614A Tray
If you purchased HP accessory G2612A separately from your HP 6890 Plus GC,
install it now. Refer to the documentation provided with the accessory for
instructions. After it is installed, continue with the steps below to install the
optional HP G2614A Tray.
1.
Unpack the injector module, tray, and bar code reader and place them on
the bench top.
2.
Remove the 3 injection port cover Torx screws shown.
Injection port cover
Figure 1
2
Installing the tray
Tray
Tray mounting
screws
Captive screw (install first)
Remove screws from
cover