Installation Guide
Installing the HP G1926A Bar Code Reader
Installing the HP G1926A Bar Code Reader
1.
Install the HP G1926A Bar Code Reader support bracket under the front of
the tray as shown below. Leave the screws slightly loose. You will tighten
them later.
Support Bracket
Figure 4
2.
Mount the Bar Code Reader onto the front of the tray base by inserting the
two mounting clips on the Bar Code Reader into the mounting slots on the
edge of the tray base. See Figure 5.
Figure 5
6
The Bar Code Reader support bracket
Mounting location for the Bar Code Reader
Tray
GC
Height adjustment screws
Mounting clips
Bar code reader
Adjust this space
Mounting screws (2)