2. Note the orientation of the DIMM in the socket so that you can insert the replacement DIMM in the proper
orientation.
Note: A notch at the bottom of the DIMM helps you align the DIMM during installation.
3. Slowly push apart on the two DIMM ejector tabs on either side of the DIMM to eject the DIMM from its slot,
and then slide it out of the slot.
Note: Carefully hold the DIMM by the edges to avoid pressure on the components on the DIMM circuit
board.
The number and placement of system DIMMs depends on the model of your system.
What to do next
Go to
Install new
DIMM.
Install new DIMMs
You install a new DIMM to replace the DIMM previously installed in the controller.
Before you begin
• If you are not already grounded, properly ground yourself.
Procedure
1. Hold the DIMM by the corners, and align it to the slot.
The notch among the pins on the DIMM should line up with the tab in the socket.
| DIMMs |
29