Remove The Host Interface Card - Fujitsu ETERNUS AB Series Hardware Maintenance Manual

6. Using two hands and the handles, slide the controller canister out of the shelf. When the front of the
controller is free of the enclosure, use two hands to pull it out completely.
Attention: Always use two hands to support the weight of a controller canister.
7. Place the controller canister on a flat, static-free surface.
What to do next
Go to Remove a host interface

Remove the host interface card

You remove the original host interface card (HIC) so you can replace it with an upgraded one.
Before you begin
• You have a #1 Phillips screwdriver.
• You have an ESD wristband, or you have taken other antistatic precautions.
Procedure
1. Remove the controller canister's cover by unscrewing the single thumbscrew and lifting the lid open.
2. Confirm that the green LED inside the controller is off.
If this green LED is on, the controller is still using battery power. You must wait for this LED to go off before
removing any components.
card.
| Host interface cards |
49