Gigastar Interface; Fig. 7-15: Assignment Of The Three Gigastar Interfaces; Fig. 7-16: Permissible Cable Length Of The Gigastar Interfaces - Bosch Rexroth IndraControl VDP 16.1 Series Project Planning Manual

7-8
Interfaces

GIGASTAR Interface

X31, X32, X33 –
GIGASTAR Interfaces
Via the 25-pin GIGASTAR interface (X31, X32, X33) the Y-Repeater is
connected, on the one hand, to the IPC and, on the other hand, to the two
VDP displays. You will find connecting cables with different length on
page 10-4 in chapter "Ordering Information" under "Accessories".
Connection Function
X31 GIGASTAR interface to IPC
X32 GIGASTAR interface to VDP1
X33 GIGASTAR interface to VDP2
Fig. 7-15: Assignment of the three GIGASTAR interfaces
Via the GIGASTAR interface the image data as well as the mouse signals
are transmitted from the IPC to the VDP displays.
Material damage by cable extension!
⇒ The cables must not be plugged together for
extension purposes, as this might damage the VDP.
CAUTION
The following cable length must not be exceeded:
Cable between IPC and Y-Repeater
Cable between Y-Repeater and VDP
Total length between IPC and VDP
Fig. 7-16: Permissible cable length of the GIGASTAR interfaces
Consider that you have to maintain all three values!
VDP 16.1, VDP 40.1 and VDP 60.1
< 15 meters
< 25 meters
< 30 meters
DOK-SUPPL*-VDP16/40/60-PR02-EN-P